[. . . ] Keep the packing materials, they are necessary to transport the machine. Remove your machine from the box and place it where it is to be installed. Do not expose the image drum unit to direct sunlight or very bright interior light (approximately more than 1500 lux). Even under the normal interior light, do not leave the image drum exposed for more than 5 minutes. [. . . ] On the [General] tab, enter the content of [Name] and [E-mail address] on lines B-9 and B-10 of the Setup Form. Click the [Server] tab, and then enter each setting in the corresponding lines of the Setup Form. Enter an email address to be used by your machine on line B-1 of the Setup Form. If the email address for your machine is specified by the network administrator, enter the email address on line B-1. If you are using an internet service provider, obtain an email address for your machine from the provider and then enter the email address on line B-1. If the email address for your machine is neither specified nor obtained, determine the email address according to the value you entered on line B-4 (authentication method): - If B-4 is "SMTP", determine an email address and enter it on line B-1. If the [My server requires authentication] check box is selected, enter "SMTP" on line B-4 of the Setup Form. - If B-4 is "POP", enter the same email address as B-12 on line B-1. If you want your machine to receive email, you must obtain an email address for your machine from a network administrator or your internet service provider. When using the arrow keys, press the key repetitively to go to the selection. If [Use the same settings as my incoming mail server] is selected, enter - the value from line B-7 on line B-5 and - the value from line B-8 on line B-6 of the Setup Form. 14 Select the user added in the previous step and select the permission level, then click [Share]. 18 Select the user added in step 13 and select the [Allow] check box for [Full Control], then click [OK]. Create a new folder on the computer with the name entered on line C-5. It is recommended to create a folder in the local drive, not on the desktop or [My Documents]. 10 Right-click the folder created in the step above, and then select [Sharing and Security]. 11 On the [Sharing] tab, select [Share this folder] and then click [Permissions]. 15 Select the [Allow] check box for [Full Control], and then click [OK]. Enter the value of C-3 in [Type a new password] and [Type the new password again to confirm], and then click [Create Password]. 10 Create a new folder on the computer with the name entered on line C-5. It is recommended to create a folder in the local drive, not on the desktop or [My Documents]. 11 Right-click the folder created in the step above, and then select [Sharing and Security]. [. . . ] C) When the confirmation message appears, press the right arrow key to select [Yes], then press <OK>. D) When the screen prompts you to turn off the power switch, turn the machine off. If [Printer Setup Utility] is already running, close it and open it again. If the name of your machine is already displayed, select it and click [Delete], and then click [Add]. [. . . ]